What this code means
P1898 can indicate the CVT drive pulley pressure control solenoid valve is stuck ON or the CVT driven pulley pressure control solenoid valve is stuck OFF.
What the vehicle may do
- The TCM can store this code when the pulley ratio is out of range.
Possible fault areas
- The drive pulley pressure control solenoid valve may be stuck ON.
- The driven pulley pressure control solenoid valve may be stuck OFF.
Diagnostic path
What P1898 means
On this 2025 Honda Accord 1.5, code P1898 can mean the CVT Drive Pulley Pressure Control Solenoid Valve is stuck ON. It can also mean the CVT Driven Pulley Pressure Control Solenoid Valve is stuck OFF. With the forward clutch engaged, the TCM monitors the pulley ratio as the vehicle goes from a stop to moving. If that ratio is outside the specified range, the TCM stores this code. Here is what this code tells us. The TCM can store this code when the pulley ratio is out of range. Here are the main areas to check. The drive pulley pressure control solenoid valve may be stuck ON. The driven pulley pressure control solenoid valve may be stuck OFF.
The code records a pulley-ratio abnormality during the transition from stopped, with the forward clutch engaged, to moving. That result does not by itself select between the two named valve conditions: drive pulley pressure control solenoid valve stuck ON and driven pulley pressure control solenoid valve stuck OFF remain distinct alternatives.
Before troubleshooting
Before you troubleshoot, review how to troubleshoot.
Listed solenoid work
The listed work item is replacement of the drive pulley valve, the driven pulley valve, or both.
Confirmation routine
The Confirmation Procedure is a separate routine. Here is how that routine works. Raise the vehicle on a lift. Make sure it is securely supported, with all four wheels able to rotate freely. Start the engine, then disable the VSA. Run the vehicle in D position/mode until the vehicle speed reaches 37 mph (60 km/h). That is the required speed for this part of the routine. Slow down and stop the wheels. Then accelerate from a stop at full throttle in D position/mode. Slow down and stop the wheels again. Then turn the vehicle to the OFF (LOCK) mode. Repeat that operating sequence: start the engine, then disable the VSA. Run in D position/mode until the vehicle speed reaches 37 mph (60 km/h). Slow down and stop the wheels. Accelerate from a stop at full throttle in D position/mode. Slow down and stop the wheels. Then turn the vehicle to the OFF (LOCK) mode.
The 37 mph (60 km/h) target belongs to the initial run in D position/mode. The full-throttle acceleration is a separate part of the routine, beginning only after the wheels have stopped. The repetition covers the complete engine-start-through-OFF (LOCK) sequence, including disabling VSA again, rather than repeating only the acceleration.
Component and scanner context
Both solenoid valves are built into the Valve Body Assembly. For this code, the listed diagnostic scanner (HDS) function is AT > Data List.
More diagnostic steps
For more diagnostic steps, visit stepdiagnostics.com.
Final check
P1898 can involve either of the two pulley pressure control solenoid valves integrated with the Valve Body Assembly.
For more guided automotive diagnostics, visit STEP Diagnostics.






