What this code means
P2279 can indicate estimated intake airflow from the PCV above the specified value.
What the vehicle may do
- The PCM may store this code when estimated PCV airflow is too high.
Possible fault areas
- Possible check areas include camshaft timing and valve clearance.
- The intake air, PCV, and EVAP systems may also need attention.
Diagnostic path
What P2279 means
On this 2025 Honda Accord 1.5, P2279 means Intake Air System Leak. If the estimated amount of intake air from the PCV exceeds a specified value, the PCM detects a fault and stores this code. Here is what this code tells us. The PCM may store this code when estimated PCV airflow is too high. Here are the main areas to check. Possible check areas include camshaft timing and valve clearance. The intake air, PCV, and EVAP systems may also need attention.
The code describes an estimated airflow condition, not a diagnosis of the PCV valve itself. Although the PCM's comparison concerns air from the PCV, the listed checks also cover camshaft timing, valve clearance, and intake and EVAP components. This separates the condition that stores P2279 from the checks used to investigate it.
Before troubleshooting
Before you troubleshoot, review How to Troubleshoot.
Check the listed prerequisite first
Troubleshoot any DTCs listed or indicated systems below first. - EVAP Canister Purge Valve \[PGM-FI\]: DTC P0443.
Camshaft timing
To check camshaft timing, do the Camshaft Timing Inspection.
Valve clearance
For valve clearance, do the Valve Clearance Adjustment.
Intake, PCV, and EVAP components
The listed check for intake system components, PCV system components, and EVAP system components is the Intake Air System Visual Inspection.
Confirmation Procedure
The Confirmation Procedure is a separate routine defined this way. Start the engine. Hold the engine speed at 3,000 rpm without load, in P or N, until the radiator fan comes on. Then let it idle for 1 minute. Use the diagnostic scanner (HDS) to monitor \[OBD STATUS (PGM-FI)\] for DTC P2279.
The confirmation sequence uses two different endpoints: radiator fan operation ends the 3,000 rpm, no-load hold in P or N; the timed 1-minute idle follows that event. The HDS [OBD STATUS (PGM-FI)] observation for P2279 comes after both stages, rather than during the higher-speed hold.
Listed scanner function
A listed scanner function is PGM-FI > Data List.
Check for vacuum leaks
The Intake Air System Visual Inspection is a separate procedure. It calls for checking for vacuum leaks at the intake air duct and intake manifold. Also check the PCV valve, PCV hose, Purge (PCS) hose, EVAP canister purge valve, and throttle body. Include all parts through the turbocharger joint to the throttle body. The normal result is no leaks. If the result is abnormal, there is a problem with components in the intake air system, PCV system, and/or EVAP system.
The distinction in this inspection is whether vacuum leaks are found at the listed parts. No leaks is the normal result for this check. An abnormal result points to components in the intake air, PCV, and/or EVAP systems; it does not mean that all three systems are faulty or identify one particular component by itself.
More diagnostic steps
For more diagnostic steps, visit stepdiagnostics.com.
Final check
Possible fault areas include camshaft timing, valve clearance, and components in the intake air, PCV, and EVAP systems.
For more guided automotive diagnostics, visit STEP Diagnostics.






